Ultimaker Nozzle for use with Olsson Block, Ultimaker 2+ 0.5mm

RS Stock No.: 110-1986Brand: UltimakerManufacturers Part No.: OBS001
brand-logo
View all in 3D Printer Parts

Technical documents

Specifications

Product Type

Nozzle

For Use With

Olsson Block, Ultimaker 2+

Nozzle Material

Stainless Steel

Nozzle Size

0.5mm

Country of Origin

Netherlands

Product details

Ultimaker 2 Jet Nozzle - Stainless Steel

The Olsson block Stainless Steel Jet nozzle has a special tip angle and shoulder width, it also has a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With this special stainless steel nozzle, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean it efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer

If you print with abbrasive material like Carbon filled filament or Glowfill, this is the nozzle to have! Stainless steel is much stronger, it will wear down much slower than classic brass nozzles which can wear out during one long print! Only thing to remember is to print a little slower because of the difference in conductivity between stainless steel and brass

Ultimaker Accessories

Stock information temporarily unavailable.

Please check again later.

Stock information temporarily unavailable.

P.O.A.

Ultimaker Nozzle for use with Olsson Block, Ultimaker 2+ 0.5mm

P.O.A.

Ultimaker Nozzle for use with Olsson Block, Ultimaker 2+ 0.5mm
Stock information temporarily unavailable.

Technical documents

Specifications

Product Type

Nozzle

For Use With

Olsson Block, Ultimaker 2+

Nozzle Material

Stainless Steel

Nozzle Size

0.5mm

Country of Origin

Netherlands

Product details

Ultimaker 2 Jet Nozzle - Stainless Steel

The Olsson block Stainless Steel Jet nozzle has a special tip angle and shoulder width, it also has a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With this special stainless steel nozzle, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean it efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer

If you print with abbrasive material like Carbon filled filament or Glowfill, this is the nozzle to have! Stainless steel is much stronger, it will wear down much slower than classic brass nozzles which can wear out during one long print! Only thing to remember is to print a little slower because of the difference in conductivity between stainless steel and brass

Ultimaker Accessories